Calcium silicate boards Light Board partition construction process quality control points

Calcium silicate boards Light Board partition construction process quality control points

(1) of the partition plate calcium silicate board construction diagram drawing review body subject to the review and by drawing conclusions should be qualified to review the record.
(2) calcium silicate lath board installation site should be cleaned on beam bottom slat junction, floors, structural walls were primary treatment, then press Install drain plate Figure bomb ink line, mark the installation position and the doors and windows of the plate hole position, after the check can be carried out slats installation and construction.
(3) calcium silicate lath wall board should adopt a standard the entire board, not the vertical board, up to no more than one adapter plate For adjacent slats joints should be staggered, staggered joint range of not less than 500 sampan, At the same time we must be prepared reinforcement, cracking process slats docking site, then board the impact strength of not less than the value of the entire board.
(4) when the end is not a standard wall plate width can be measured size patch panels, patch panels but the standard width of not less than 1/2 of the plate width, mounted in place of the plate may not have a horizontal, vertical cracks and broken ribs residues angle.
(5) concrete slabs or beams end and the strip joints, tongue and groove at the top surface of the strip and stair slats should be uniform scraping full thickness of not less than 5 Shan after fixing adhesive material. (6) laid electrical lines on the strip walls, switches and sockets should take advantage of the strip hollow hole laying pipelines and installation box, not transverse slotted laying pipeline on the slat wall.
(7) the choice of doors, window frames plates, with the wall thickness of the slab should be equivalent, doors, window frames should be set embedded board member and doors, fixed window frames, doors, window frames and window and door openings board seams to be taken special sealing, sound insulation, crack and other measures.
(8) of the partition wall plate installation response to take protective measures to prevent collisions and wall construction machinery watering.

TOP RANKS
Similar Articles Top
News Articles
Your Browsing History
Home|Products| Case|News|Contact Us|About Us

营销型网站建设

2015-2020 China Kunming City Hing Building Material Co., Ltd [Yunnan ICP No. 15006559] easy network extension Technical Support
Sales Tel: 0871-67881188; 0871-67882288 Fax: 0871-67883666 E-mail: 2025562536@qq.com
Website: www.jiudejiancai.com Address: Kunming Jinning County Jincheng Industrial Park
Main products: fiber cement board, calcium silicate board, explosion relief panels, wood panels, ceiling panels, composite panels